A client recently had the need for four tanks to be manufactured and delivered in under four weeks after being let down by another supplier, however Metcraft came to the rescue and delivered them directly to the client within 3 Continue reading →

Here at Metcraft we design, manufacture and install diesel fuel polishing systems – all completed by our in-house engineers.

The photos below are of a Metcraft fuel polishing system we have designed to be retrofitted on a customer’s Continue reading →

It was good to go to site today to see some of our 45,000litre structural slab tanks being installed under our client’s generator sets. We have currently built 19 of the 29 on order. As you can see, the slabs Continue reading →

Metcraft Group LTD buy out JA Envirotanks LTD assets and IP rights.

After over 150 years of trading, JA Envirotanks have had their assets and IP rights purchased by Metcraft Group LTD to become one of the largest steel storage Continue reading →

We have recently completed the manufacture of a bunded fuel tank built to a water board specification.

This consisted of a special highly-resistant paint finish as well as an extended bund space accessible via a lockable hatch, which housed the Continue reading →

The latest of our successful projects featured two double-skinned 32,000L fuel tanks being delivered to a data centre in Wiltshire.

Both tanks have a bulkhead section to house our anti-vibration standby duplex fuel pump set complete with a hand pump Continue reading →

We have recently completed the manufacture of three oil drain pans which will be used for the maintenance of large military vehicles at a MOD site.

The drain pans are fitted with heavy duty oil-resistant casters and a fold-away handle Continue reading →

We have recently completed the manufacture of a dual duplex duty standby fuel pump set complete with drip tray, skid, duplex strainer and water separator filter to protect the pump and generator sets from contaminated diesel fuel.

The duplex filter Continue reading →

Tanks leaving the factory, ready for delivery to site

We were commissioned to manufacture twelve 10,000L bunded tanks to strict specification.

As well as the twelve tanks, they also required a gantry to allow access to the connections and pump Continue reading →